Plug & Play PID Programmable Temperature Controller Box SSR Kiln Annealing Glaze

Description

This plug and play PID Programmable Ramp and Soak (60 segments) temperature controller with Ceramic thermocouple, has a wide range of applications in controlling the temperature of Kilns, Ovens, Furnaces, pottery, Glass, Annealing, ....
(for loading current up to 15Amp) . This is an inexpensive and heavy duty plug and play controller box.
All products are 100% Brand new, High performance and Top quality.
Controller comes in Box with
MANUAL
.
Guarantee your
Insured
Undamaged
shipping by purchasing from a Canada located seller.
Ready for Immediate Shipment.
Features & Specifications
:
·
Its heavy duty kiln thermocouple can measure very high temperatures up to 2372 °F (1300 °C).
·
To operate, you only need to plug the heater to the socket wire of the controller at the back, drop the sensor into the Kiln, turn on the power of controller and adjust it to your own requirements.
·
Display temperature in Celsius or Fahrenheit
·
Heavy duty input and output plug and socket wire
·
Equipped with
circuit breaker
switch 15Amp (The circuit breaker can be reset and used over and over, where a fuse is a one shot deal and has to be replaced)
·
Equipped with
Thermocouple male and female connector for changing thermocouple and also  wall mount box ear for easy installing on oven or wall.
·
Equipped with 40amp SSR with large Heat sink
Specifications
:
Input voltage
90 to 265 VAC - 50 /60 Hz; No transformer or adaptor is required.
Output voltage
Same as the input.
Maximum Current
15A
Controller Mode
60 segments Ramp and soak PID control
Output switching device
Solid State Relay (max 15A - 24/240V AC) with zero voltage crossing switching.
Sensor Type
Type K 6pc Ceramic Kiln Thermocouple
Temperature control range
50 to 1300 °C
Thermocouple Thread material
Cr-Ni, Si-Ni
Thermocouple Thread dimensions
3.2mm (diameter ɸ) x 190 mm (long) / (0.13" x 7.5")
Sensor cable length
3.3 ft (1m)
Ceramic tube shape
6 x (1 inch Pcs, two-hole insulator) Ceramic Tube
Ceramic tube diameter
Oval shape: L=12.3 mm & W=10mm (L~ 0.5” & W~ 0.4”)
Ceramic tube length
~150 mm (~ 6.0 inch)
Box material
ABS
Temperature resolution
Dual 4-digit LED display, 0.1 °C.
Temperature display unit
Celsius (°C)
Temperature accuracy
±0.5%F.S
Dimension
200x120x75mm ( 7 3/4 x 4 3/4 x 3" )
Temperature controller specification:
Available Segments
Up to 60 segments available for a program
Detective Temperature Range
-200 to 1800 °C (depends on input type)
Patterns
Be able to program different patterns with different segments
Input
Thermocouple: (K,S,E,J,T,B,N)
RTD: (Cu50, PT100)
Linear Voltage and current:0-5V,1-5V,0-1V,0-100mV,0-20mV,0-60mV,0.2-1V(100-500mV),-20 -+20mV(0-10V) -5V- +5V(0-50V), -100 - +100mV(2-10V)
Linear Resistor:0-80 Ohm, 0-400 Ohm
Output
Voltage pulse to drive SSR
Control action
Heating , Cooling
Response time
Less than 0.5S (configurable)
Accuracy
0.2%FS+- 0.1C(Cu50 cooper resistor compensation or ice point compensation)
0.2%FS+0.2C (TC input and internal compensation)
Temperature drift
Less than 0.01%FS
0
C (Typical value is 50ppm/
0
C)
Resolution
1
0
C or 0.1
0
C(automatically change to 1
0
C when the temperature is higher than 999)
Display
Dual line - four digit - LED display
Decimal points
Configurable for all inputs
Control Method
ON/OFF
AI MPT with auto tuning, adopting fuzzy logic PID algorithm
Auto/Manual Control
Auto/manual bump less transfer from front panel
Auto-tuning
Auto-tuning and manual tuning available
Alarm Mode
Absolute value high limit, Absolute value low limit, Deviation high limit alarm, Deviation low limit alarm.
Alarm stand by
In some occasions, for example, in the heating process, when the alarm is set to as low deviation alarm, right after the power is turned on, the alarm will be triggered but there is no problem in the system, the alarm block function can solve this problem.
Soft start function
In some particular application, 100% output ratio is not allowed when the power just turned on; soft start function is a great feature to solve this problem.
SV re-transmission output
available, as feed of PLC or indicator or paperless recorder
Power Supply
90~260VAC
Dimension (DIN 1/8)
96mm*48mm (Horizontal)
Mounting
Panel Mount
Notes for customer outside North America,
For international order, an US power cord is included. User can cut plug and socket wire and change it to the power plug and socket outlet that meets the local standard for the input and output.
For countries that use 220-240VAC power line, the maximum control power of this controller is 3300 Watts.
Our shipping service is fast for example:
shipping to USA is 3-6 business days
shipping to England and Ireland is 4-7 business days
shipping to other Europe Countries 5-10 business days
shipping to Canada is 2-7 business days
shipping to Australia, New Zealand and Asia takes longer than other countries (17-25 Business days)